GATE 2014 ME Set 4 · Question 52
A plane wall has a thermal conductivity of . If the inner surface is at and the outer surface is at , then the design thickness (in meter) of the wall to maintain a steady heat flux of should be _______
GATE 2014 · Mechanical Engineering · Set 4 · IIT Kharagpur · printed as Q.42 in the ME section
Answer
From the official answer key published by IIT Kharagpur.
Worked solution
According to Fourier's law of one-dimensional steady-state heat conduction, the heat flux through a plane wall of thickness is given by:
where:
- Thermal conductivity,
- Temperature difference,
- Steady heat flux,
Rearranging to solve for the wall thickness :
Substitute the given values:
Answer: 0.345
Practise 1D Steady Conduction, Resistance & Critical Insulation
17 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from 1D Steady Conduction, Resistance & Critical Insulation
- GATE 2022 ME Set 1 · Q60Consider a one-dimensional steady heat conduction process through a solid slab of thickness 0.1 m. The…
- GATE 2022 ME Set 1 · Q64Consider a solid slab (thermal conductivity, k = 10 W×m-1×K-1) with thickness 0.2 m and of infinite extent…
- GATE 2021 ME Set 1 · Q53An uninsulated cylindrical wire of radius 1.0 mm produces electric heating at the rate of 5.0 W/m. The…
- GATE 2020 ME Set 2 · Q34In a furnace, the inner and outer sides of the brick wall (k1 = 2.5 W/m.K) are maintained at 1100°C and…
- GATE 2019 ME Set 1 · Q21A slender rod of length L, diameter d (L d) and thermal conductivity k1 is joined with another rod of…
- GATE 2018 ME Set 1 · Q57A plane slab of thickness L and thermal conductivity k is heated with a fluid on one side (P), and the other…
Question from the official GATE 2014 ME paper (Set 4), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.