GATE 2016 ME Set 3 · Question 18
The state of stress at a point on an element is shown in figure (a). The same state of stress is shown in another coordinate system in figure (b).
The components are given by
- A
- B
- C
- D
GATE 2016 · Mechanical Engineering · Set 3 · IISc Bangalore · printed as Q.8 in the ME section
Answer
From the official answer key published by IISc Bangalore.
Worked solution
Figure (a) shows an element subjected to pure biaxial tension and compression along directions oriented at to the horizontal. Since there is no shear stress on these inclined planes, they are principal planes with principal stresses:
Using the stress transformation equations for planes oriented at angle from the principal plane:
Alternatively, a state of pure shear on orthogonal planes is identically equivalent to principal stresses oriented at .
Thus, .
Answer: (B)
Practise Complex Stresses, Plane Strain and Mohr's Circle
16 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Complex Stresses, Plane Strain and Mohr's Circle
- GATE 2015 ME Set 2 · Q44In a plane stress condition, the components of stress at a point are σx = 20 MPa, σy = 80 MPa and τxy = 40…
- GATE 2014 ME Set 1 · Q40The state of stress at a point is given by σx = -6 MPa, σy = 4 MPa, and τxy = -8 MPa. The maximum tensile…
- GATE 2014 ME Set 2 · Q21A thin plate of uniform thickness is subject to pressure as shown in the figure below Under the assumption…
- GATE 2012 ME · Q34The state of stress at a point under plane stress condition is σxx = 40 MPa, σyy = 100 MPa and τxy = 40 MPa.…
- GATE 2026 ME · Q52A welded square plate of 1 m × 1 m is subjected to biaxial stress of magnitude 6.5 MPa and 25 MPa, as shown…
- GATE 2025 ME · Q28A metallic square plate is subjected to a uniform hydrostatic pressure (P). Choose the correct Mohr's circle…
Question from the official GATE 2016 ME paper (Set 3), IISc Bangalore. Solutions by PARIXO AI. All 65 questions of this paper.