GATE 2020 ME Set 1 · Question 59
Consider steady, viscous, fully developed flow of a fluid through a circular pipe of internal diameter . We know that the velocity profile forms a paraboloid about the pipe centre line, given by: , where is a constant. The rate of kinetic energy (in ) at the control surface A-B, as shown in the figure, is proportional to . The value of is ________.
GATE 2020 · Mechanical Engineering · Set 1 · IIT Delhi · printed as Q.49 in the ME section
Answer
From the official answer key published by IIT Delhi.
Worked solution
The velocity profile for fully developed laminar flow through a pipe of diameter (radius ) is given by:
The rate of kinetic energy flux across the control surface A-B is:
Substitute into the integral:
Let , where , so and :
Substituting this back into the integral:
Since the remaining integral is a dimensionless constant, we have:
Therefore, .
Answer: 8
Practise Laminar flow
17 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Laminar flow
- GATE 2019 ME Set 1 · Q55Two immiscible, incompressible, viscous fluids having same densities but different viscosities are contained…
- GATE 2019 ME Set 2 · Q33Water enters a circular pipe of length L = 5.0 m and diameter D = 0.20 m with Reynolds number ReD = 500. The…
- GATE 2019 ME Set 2 · Q53Water flows through two different pipes A and B of the same circular cross-section but at different flow…
- GATE 2016 ME Set 2 · Q50Consider fluid flow between two infinite horizontal plates which are parallel (the gap between them being 50…
- GATE 2016 ME Set 3 · Q49Consider a fully developed steady laminar flow of an incompressible fluid with viscosity μ through a…
- GATE 2015 ME Set 2 · Q50The head loss for a laminar incompressible flow through a horizontal circular pipe is h1. Pipe length and…
Question from the official GATE 2020 ME paper (Set 1), IIT Delhi. Solutions by PARIXO AI. All 65 questions of this paper.