GATE 2020 ME Set 1 · Question 63
For an ideal Rankine cycle operating between pressures of and , the work output from the turbine is and the work input to the feed pump is . The specific steam consumption is ________ kg/kW.h *(round off to 2 decimal places)*.
GATE 2020 · Mechanical Engineering · Set 1 · IIT Delhi · printed as Q.53 in the ME section
Answer
From the official answer key published by IIT Delhi.
Worked solution
The net work output of the Rankine cycle per unit mass of steam is:
where:
- is the turbine work output
- is the pump work input
Specific steam consumption (SSC) is defined as the steam flow rate required per unit power output:
where .
Answer: 4.00
Practise Vapour Power Cycles (Rankine, Reheat, Regeneration)
17 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Vapour Power Cycles (Rankine, Reheat, Regeneration)
- GATE 2020 ME Set 2 · Q64In a steam power plant, superheated steam at 10 MPa and 500°C, is expanded isentropically in a turbine until…
- GATE 2019 ME Set 1 · Q59A steam power cycle with regeneration as shown below on the T-s diagram employs a single open feedwater…
- GATE 2019 ME Set 2 · Q23Which one of the following modifications of the simple ideal Rankine cycle increases the thermal efficiency…
- GATE 2017 ME Set 2 · Q42In the Rankine cycle for a steam power plant the turbine entry and exit enthalpies are 2803 kJ/kg and 1800…
- GATE 2016 ME Set 1 · Q29The INCORRECT statement about regeneration in vapor power cycle is that
- GATE 2016 ME Set 1 · Q57In a steam power plant operating on an ideal Rankine cycle, superheated steam enters the turbine at 3 MPa…
Question from the official GATE 2020 ME paper (Set 1), IIT Delhi. Solutions by PARIXO AI. All 65 questions of this paper.