PARIXO GATE · ME Open the app

GATE 2021 ME Set 2 · Question 60

2 marksNumerical answerThermodynamicsEntropy & Principle of Entropy Increase

An adiabatic vortex tube, shown in the figure given below is supplied with of air (inlet 1) at and . Two separate streams of air are leaving the device from outlets 2 and 3. Hot air leaves the device at a rate of from outlet 2 at and , and of cold air stream is leaving the device from outlet 3 at and .

Assume constant specific heat of air is and gas constant is . There is no work transfer across the boundary of this device. The rate of entropy generation is \_\_\_\_\_\_\_\_\_\_\_ *(round off to one decimal place)*.

Figure 1 for GATE 2021 ME Set 2 question 60

GATE 2021 · Mechanical Engineering · Set 2 · IIT Bombay · printed as Q.50 in the ME section

Answer
2.1 to 2.3

From the official answer key published by IIT Bombay.

Worked solution

For an adiabatic control volume at steady state with negligible heat transfer (), the rate of entropy generation is given by:

For an ideal gas with constant specific heat:

Given:

  • ,
  • State 1: , ,
  • State 2: , ,
  • State 3: , ,

For outlet 2:

For outlet 3:

Total entropy generation rate:

Answer: 2.2

Practise Entropy & Principle of Entropy Increase

17 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.

More from Entropy & Principle of Entropy Increase

Question from the official GATE 2021 ME paper (Set 2), IIT Bombay. Solutions by PARIXO AI. All 65 questions of this paper.