GATE 2022 ME Set 1 · Question 50
Two rigid massless rods PR and RQ are joined at frictionless pin-joint R and are resting on ground at P and Q, respectively, as shown in the figure. A vertical force acts on the pin R as shown. When the included angle , the rods remain in static equilibrium due to Coulomb friction between the rods and ground at locations P and Q. At , impending slip occurs simultaneously at points P and Q. Then the ratio of the coefficient of friction at Q to that at P () is \rule{2cm}{0.15mm} *(round off to two decimal places)*.
GATE 2022 · Mechanical Engineering · Set 1 · IIT Kharagpur
Answer
From the official answer key published by IIT Kharagpur.
Worked solution
Rods and are rigid and massless, connected by a frictionless pin at with no external loads along their lengths. Therefore, each rod is a two-force member, and the reaction forces at contacts and must act along the axes of and , respectively.
Let and be the inclination angles of rods and with the horizontal ground. Since the included angle at is :
Both rods meet at pin at the same vertical height :
Since the resultant ground reaction at each support is collinear with the corresponding rod, the ratio of horizontal friction to normal reaction at impending slip is:
Taking the ratio:
Answer: 5.76
Practise Dry Friction, Wedges, Screws and Rolling Resistance
10 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Dry Friction, Wedges, Screws and Rolling Resistance
- GATE 2021 ME Set 2 · Q61A block of negligible mass rests on a surface that is inclined at 30° to the horizontal plane as shown in…
- GATE 2019 ME Set 1 · Q29A block of mass 10 kg rests on a horizontal floor. The acceleration due to gravity is 9.81 m/s2. The…
- GATE 2016 ME Set 1 · Q40A block of mass m rests on an inclined plane and is attached by a string to the wall as shown in the figure.…
- GATE 2014 ME Set 1 · Q41A block R of mass 100 kg is placed on a block S of mass 150 kg as shown in the figure. Block R is tied to…
- GATE 2014 ME Set 1 · Q45A block weighing 200 N is in contact with a level plane whose coefficients of static and kinetic friction…
- GATE 2014 ME Set 2 · Q46A truck accelerates up a 10° incline with a crate of 100 kg. Value of static coefficient of friction between…
Question from the official GATE 2022 ME paper (Set 1), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.