GATE 2025 ME · Question 51
Water enters a tube of diameter, with mass flow rate of as shown in the figure below. The inlet mean temperature is and the uniform heat flux at the surface of the tube is . For the exit mean temperature of , the length of the tube, is ________m (*rounded off to 1 decimal place*).
Use the specific heat of water as .
GATE 2025 · Mechanical Engineering · IIT Roorkee
Answer
From the official answer key published by IIT Roorkee.
Worked solution
From the energy balance for fluid flow in a tube with uniform surface heat flux :
The total heat transfer rate is also given by the surface area multiplied by the heat flux:
Equating the two expressions for :
Given:
- ,
Substitute these values into the equation:
Rounded to one decimal place, .
Answer: 6.7
Practise External & Internal Forced Convection Correlations
14 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from External & Internal Forced Convection Correlations
- GATE 2024 ME · Q18Consider incompressible laminar flow over a flat plate with freestream velocity of u . The Nusselt number…
- GATE 2024 ME · Q19Consider a hydrodynamically fully developed laminar flow through a circular pipe with the flow along the…
- GATE 2023 ME · Q21Consider incompressible laminar flow of a constant property Newtonian fluid in an isothermal circular tube.…
- GATE 2022 ME Set 2 · Q65Consider a hydrodynamically and thermally fully-developed, steady fluid flow of 1 kg/s in a uniformly heated…
- GATE 2020 ME Set 2 · Q61Water flows through a tube of 3 cm internal diameter and length 20 m. The outside surface of the tube is…
- GATE 2019 ME Set 1 · Q19For a hydrodynamically and thermally fully developed laminar flow through a circular pipe of constant…
Question from the official GATE 2025 ME paper, IIT Roorkee. Solutions by PARIXO AI. All 65 questions of this paper.