GATE 2014 ME Set 1 · Question 57
In an air-standard Otto cycle, air is supplied at and . The ratio of the specific heats () and the specific gas constant () of air are and , respectively. If the compression ratio is and the maximum temperature in the cycle is , the heat (in kJ/kg) supplied to the engine is ________
GATE 2014 · Mechanical Engineering · Set 1 · IIT Kharagpur · printed as Q.47 in the ME section
Answer
From the official answer key published by IIT Kharagpur.
Worked solution
In an air-standard Otto cycle, the specific heat at constant volume is given by:
The temperature after isentropic compression (process ) with compression ratio is:
Heat is supplied during the constant volume process , where :
Answer: 1409.6
Practise Air-Standard IC Engine Cycles (Otto, Diesel, Dual)
14 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Air-Standard IC Engine Cycles (Otto, Diesel, Dual)
- GATE 2014 ME Set 3 · Q59A diesel engine has a compression ratio of 17 and cut-off takes place at 10% of the stroke. Assuming ratio…
- GATE 2014 ME Set 4 · Q59In a compression ignition engine, the inlet air pressure is 1 bar and the pressure at the end of isentropic…
- GATE 2025 ME · Q32The thermal efficiency of an ideal air-standard Otto cycle is 0.5. The value of specific heat ratio of air…
- GATE 2022 ME Set 1 · Q62An engine running on an air standard Otto cycle has a displacement volume 250 cm3 and a clearance volume…
- GATE 2020 ME Set 1 · Q65The indicated power developed by an engine with compression ratio of 8, is calculated using an air-standard…
- GATE 2020 ME Set 2 · Q27For an air-standard Diesel cycle,
Question from the official GATE 2014 ME paper (Set 1), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.