GATE 2014 ME Set 2 · Question 51
A spherical balloon with a diameter of 10 m, shown in the figure below is used for advertisements. The balloon is filled with helium () at ambient conditions of and 100 kPa. Assuming no disturbances due to wind, the maximum allowable weight (in newton) of balloon material and rope required to avoid the fall of the balloon () is _______
GATE 2014 · Mechanical Engineering · Set 2 · IIT Kharagpur · printed as Q.41 in the ME section
Answer
From the official answer key published by IIT Kharagpur.
Worked solution
Given:
- Diameter of the balloon,
- Ambient temperature,
- Ambient pressure,
The volume of the spherical balloon is:
Using the ideal gas law :
To prevent the balloon from falling, the buoyancy force must balance the total weight (helium + material and rope):
Answer: 5311
Practise Buoyancy and floatation
8 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Buoyancy and floatation
- GATE 2022 ME Set 2 · Q62A uniform wooden rod (specific gravity = 0.6, diameter = 4 cm and length = 8 m) is immersed in the water and…
- GATE 2020 ME Set 2 · Q24Which of the following conditions is used to determine the stable equilibrium of all partially submerged…
- GATE 2019 ME Set 1 · Q56A cube of side 100 mm is placed at the bottom of an empty container on one of its faces. The density of the…
- GATE 2017 ME Set 2 · Q16For the stability of a floating body the
- GATE 2016 ME Set 1 · Q24For a floating body, buoyant force acts at the
- GATE 2016 ME Set 2 · Q49The large vessel shown in the figure contains oil and water. A body is submerged at the interface of oil and…
Question from the official GATE 2014 ME paper (Set 2), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.