GATE 2014 ME Set 3 · Question 53
A siphon is used to drain water from a large tank as shown in the figure below. Assume that the level of water is maintained constant. Ignore frictional effect due to viscosity and losses at entry and exit. At the exit of the siphon, the velocity of water is
- A
- B
- C
- D
GATE 2014 · Mechanical Engineering · Set 3 · IIT Kharagpur · printed as Q.43 in the ME section
Answer
From the official answer key published by IIT Kharagpur.
Worked solution
Applying Bernoulli's equation between point at the free surface of the tank and point at the siphon exit:
Both point and point are open to the atmosphere, so . Since the tank is large and the water level is maintained constant, the velocity at the free surface is negligible ().
Substituting these into Bernoulli's equation:
Thus, the exit velocity depends only on the elevation difference between the reservoir surface and the siphon exit, independent of the summit height and inlet height .
Answer: (B)
Practise Fluid dynamics and flow measurement
20 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Fluid dynamics and flow measurement
- GATE 2013 ME · Q29Water is coming out from a tap and falls vertically downwards. At the tap opening, the stream diameter is 20…
- GATE 2012 ME · Q40A large tank with a nozzle attached contains three immiscible, inviscid fluids as shown. Assuming that the…
- GATE 2026 ME · Q24A steady incompressible laminar flow passes through a 90° tube bend placed on a horizontal surface. In…
- GATE 2026 ME · Q26Bernoulli's equation CANNOT be applied between
- GATE 2025 ME · Q16Consider two identical tanks with a bottom hole of diameter d. One tank is filled with water and the other…
- GATE 2025 ME · Q49A pitot tube connected to a U-tube mercury manometer measures the speed of air flowing in the wind tunnel as…
Question from the official GATE 2014 ME paper (Set 3), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.