GATE 2015 ME Set 1 · Question 63
Water () flows through a venturimeter with inlet diameter and throat diameter . The inlet and throat gauge pressures are measured to be and respectively. Assuming the venturimeter to be horizontal and neglecting friction, the inlet velocity (in m/s) is _______
GATE 2015 · Mechanical Engineering · Set 1 · IIT Kanpur
Answer
From the official answer key published by IIT Kanpur.
Worked solution
Let the inlet and throat be denoted by subscripts and , respectively.
Diameters are and .
From the continuity equation for incompressible flow:
Applying Bernoulli's equation between sections 1 and 2 for a horizontal venturimeter with no friction:
Given , and :
Answer: 6
Practise Fluid dynamics and flow measurement
20 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Fluid dynamics and flow measurement
- GATE 2015 ME Set 3 · Q46A Prandtl tube (Pitot-static tube with C=1) is used to measure the velocity of water. The differential…
- GATE 2014 ME Set 3 · Q53A siphon is used to drain water from a large tank as shown in the figure below. Assume that the level of…
- GATE 2013 ME · Q29Water is coming out from a tap and falls vertically downwards. At the tap opening, the stream diameter is 20…
- GATE 2012 ME · Q40A large tank with a nozzle attached contains three immiscible, inviscid fluids as shown. Assuming that the…
- GATE 2026 ME · Q24A steady incompressible laminar flow passes through a 90° tube bend placed on a horizontal surface. In…
- GATE 2026 ME · Q26Bernoulli's equation CANNOT be applied between
Question from the official GATE 2015 ME paper (Set 1), IIT Kanpur. Solutions by PARIXO AI. All 65 questions of this paper.