GATE 2015 ME Set 3 · Question 35
An air-standard Diesel cycle consists of the following processes:
1-2: Air is compressed isentropically.
2-3: Heat is added at constant pressure.
3-4: Air expands isentropically to the original volume.
4-1: Heat is rejected at constant volume.
If and denote the specific heat ratio and temperature, respectively, the efficiency of the cycle is
- A
- B
- C
- D
GATE 2015 · Mechanical Engineering · Set 3 · IIT Kanpur
Answer
From the official answer key published by IIT Kanpur.
Worked solution
The thermal efficiency of an air-standard cycle is defined as:
For the given air-standard Diesel cycle:
1. Heat addition occurs during the constant-pressure process 2-3:
2. Heat rejection occurs during the constant-volume process 4-1:
Substituting and into the efficiency formula:
Using the definition of the heat capacity ratio :
Answer: (B)
Practise Air-Standard IC Engine Cycles (Otto, Diesel, Dual)
14 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Air-Standard IC Engine Cycles (Otto, Diesel, Dual)
- GATE 2014 ME Set 1 · Q57In an air-standard Otto cycle, air is supplied at 0.1 MPa and 308 K. The ratio of the specific heats (γ) and…
- GATE 2014 ME Set 3 · Q59A diesel engine has a compression ratio of 17 and cut-off takes place at 10% of the stroke. Assuming ratio…
- GATE 2014 ME Set 4 · Q59In a compression ignition engine, the inlet air pressure is 1 bar and the pressure at the end of isentropic…
- GATE 2025 ME · Q32The thermal efficiency of an ideal air-standard Otto cycle is 0.5. The value of specific heat ratio of air…
- GATE 2022 ME Set 1 · Q62An engine running on an air standard Otto cycle has a displacement volume 250 cm3 and a clearance volume…
- GATE 2020 ME Set 1 · Q65The indicated power developed by an engine with compression ratio of 8, is calculated using an air-standard…
Question from the official GATE 2015 ME paper (Set 3), IIT Kanpur. Solutions by PARIXO AI. All 65 questions of this paper.