PARIXO GATE · ME Open the app

GATE 2015 ME Set 3 · Question 45

2 marksMultiple choiceManufacturing EngineeringNC/CNC Machines, CAD/CAM and Additive Manufacturing

In a CNC milling operation, the tool has to machine the circular arc from point to at sequence number 5 of the CNC part program. If the center of the arc is at and the machine has incremental mode of defining position coordinates, the correct tool path command is

  1. A

    N 05 G90 G01 X-10 Y-10 R10

  2. B

    N 05 G91 G03 X-10 Y-10 R10

  3. C

    N 05 G90 G03 X20 Y20 R10

  4. D

    N 05 G91 G02 X20 Y20 R10

GATE 2015 · Mechanical Engineering · Set 3 · IIT Kanpur

Answer
(B)

From the official answer key published by IIT Kanpur.

Worked solution

The motion is defined in the incremental mode, which requires the preparatory code . In the incremental mode, the target position coordinates are measured relative to the start point :

To determine the direction of circular interpolation, identify the start and end vectors with respect to the center :

  • Start point relative to center: , which corresponds to an angle of .
  • End point relative to center: , which corresponds to an angle of .

Moving from to on the arc is counter-clockwise (CCW), requiring code .

The radius of the arc is:

Combining the sequence number, positioning mode, interpolation code, incremental displacements, and arc radius yields:

Answer: (B) N 05 G91 G03 X-10 Y-10 R10

Practise NC/CNC Machines, CAD/CAM and Additive Manufacturing

30 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.

More from NC/CNC Machines, CAD/CAM and Additive Manufacturing

Question from the official GATE 2015 ME paper (Set 3), IIT Kanpur. Solutions by PARIXO AI. All 65 questions of this paper.