GATE 2015 ME Set 3 · Question 44
Orthogonal turning of a mild steel tube with a tool of rake angle is carried out at a feed of . If the thickness of the chip produced is , the values of shear angle and shear strain will be respectively
- A
and
- B
and
- C
and
- D
and
GATE 2015 · Mechanical Engineering · Set 3 · IIT Kanpur
Answer
From the official answer key published by IIT Kanpur.
Worked solution
In orthogonal turning, the uncut chip thickness is , and the deformed chip thickness is .
The chip thickness ratio is:
Given rake angle , the shear angle is obtained from Merchant's relation:
The shear strain during chip formation is:
Thus, and , which corresponds to option (A).
Answer: (A) and
Practise Mechanics of Orthogonal Metal Cutting
27 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Mechanics of Orthogonal Metal Cutting
- GATE 2014 ME Set 1 · Q33The main cutting force acting on a tool during the turning (orthogonal cutting) operation of a metal is 400…
- GATE 2014 ME Set 1 · Q62During pure orthogonal turning operation of a hollow cylindrical pipe, it is found that the thickness of the…
- GATE 2014 ME Set 3 · Q30A straight turning operation is carried out using a single point cutting tool on an AISI 1020 steel rod. The…
- GATE 2014 ME Set 3 · Q64Which pair of following statements is correct for orthogonal cutting using a single-point cutting tool? P.…
- GATE 2014 ME Set 4 · Q33Better surface finish is obtained with a large rake angle because
- GATE 2013 ME · Q52Statement for Linked Answer Questions 52 and 53: In orthogonal turning of a bar of 100 mm diameter with a…
Question from the official GATE 2015 ME paper (Set 3), IIT Kanpur. Solutions by PARIXO AI. All 65 questions of this paper.