GATE 2016 ME Set 2 · Question 33
The value of true strain produced in compressing a cylinder to half its original length is
- A
0.69
- B
- C
0.5
- D
GATE 2016 · Mechanical Engineering · Set 2 · IISc Bangalore · printed as Q.23 in the ME section
Answer
From the official answer key published by IISc Bangalore.
Worked solution
True strain () is defined in terms of instantaneous length and original length as:
Given that the cylinder is compressed to half its original length, the final length is .
Substituting this into the formula:
The negative sign indicates compressive strain. Option (A) represents tensile strain of the same magnitude, while options (C) and (D) correspond to engineering strain values.
Answer: (B)
Practise Simple Stress, Strain and Elastic Constants
22 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Simple Stress, Strain and Elastic Constants
- GATE 2016 ME Set 3 · Q30Engineering strain of a mild steel sample is recorded as 0.100%. The true strain is
- GATE 2016 ME Set 3 · Q43A square plate of dimension L × L is subjected to a uniform pressure load p = 250 MPa on its edges as shown…
- GATE 2015 ME Set 2 · Q17A rod is subjected to a uni-axial load within linear elastic limit. When the change in the stress is 200…
- GATE 2014 ME Set 1 · Q17A metallic rod of 500 mm length and 50 mm diameter, when subjected to a tensile force of 100 kN at the ends,…
- GATE 2014 ME Set 2 · Q34The relationship between true strain ( T) and engineering strain ( E) in a uniaxial tension test is given as
- GATE 2014 ME Set 4 · Q17If the Poisson's ratio of an elastic material is 0.4, the ratio of modulus of rigidity to Young's modulus is…
Question from the official GATE 2016 ME paper (Set 2), IISc Bangalore. Solutions by PARIXO AI. All 65 questions of this paper.