GATE 2016 ME Set 2 · Question 34
The following data is applicable for a turning operation. The length of job is , diameter of job is , feed rate is and optimum cutting speed is . The machining time (in min) is ________
GATE 2016 · Mechanical Engineering · Set 2 · IISc Bangalore · printed as Q.24 in the ME section
Answer
From the official answer key published by IISc Bangalore.
Worked solution
The machining time for a turning operation is given by:
where:
- is the length of the job,
- is the feed rate,
- is the rotational speed in .
The spindle speed is calculated from the cutting speed and diameter :
Substituting into the expression for machining time:
Answer: 7.54
Practise Basic Machine Tools and Operations
24 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Basic Machine Tools and Operations
- GATE 2016 ME Set 3 · Q33Internal gears are manufactured by
- GATE 2015 ME Set 3 · Q16In a machining operation, if the generatrix and directrix both are straight lines, the surface obtained is
- GATE 2015 ME Set 3 · Q59A shaft of length 90 mm has a tapered portion of length 55 mm. The diameter of the taper is 80 mm at one end…
- GATE 2014 ME Set 2 · Q32Match the Machine Tools (Group A) with the probable Operations (Group B): | Group A | Group B | | :--- |…
- GATE 2014 ME Set 2 · Q64A hole of 20 mm diameter is to be drilled in a steel block of 40 mm thickness. The drilling is performed at…
- GATE 2014 ME Set 4 · Q31Two separate slab milling operations, 1 and 2, are performed with identical milling cutters. The depth of…
Question from the official GATE 2016 ME paper (Set 2), IISc Bangalore. Solutions by PARIXO AI. All 65 questions of this paper.