GATE 2016 ME Set 3 · Question 53
A cylindrical steel rod, in diameter and in length is first heated to and then immersed in a water bath at . The heat transfer coefficient is . The density, specific heat and thermal conductivity of steel are , , and , respectively. The time required for the rod to reach is ______ seconds.
GATE 2016 · Mechanical Engineering · Set 3 · IISc Bangalore · printed as Q.43 in the ME section
Answer
From the official answer key published by IISc Bangalore.
Worked solution
First, evaluate the Biot number to check whether the lumped capacitance method is applicable. The characteristic length for a cylinder of diameter and length is:
Checking the Biot number:
Since , the lumped capacitance method is valid:
Substitute the given values (, , ):
Solving for time :
(If end areas are neglected, , yielding .)
Answer: 43.5 (or a value in 42 to 45)
Practise Unsteady State Heat Conduction
10 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Unsteady State Heat Conduction
- GATE 2014 ME Set 1 · Q22Biot number signifies the ratio of
- GATE 2013 ME · Q30A steel ball of diameter 60 mm is initially in thermal equilibrium at 1030°C in a furnace. It is suddenly…
- GATE 2026 ME · Q35A sphere of radius 5 mm is initially in equilibrium at 400 °C in a furnace. It is suddenly removed from the…
- GATE 2023 ME · Q47A very large metal plate of thickness d and thermal conductivity k is cooled by a stream of air at…
- GATE 2021 ME Set 1 · Q23A hot steel spherical ball is suddenly dipped into a low temperature oil bath. Which of the following…
- GATE 2020 ME Set 1 · Q44A small metal bead (radius 0.5 mm), initially at 100°C, when placed in a stream of fluid at 20°C, attains a…
Question from the official GATE 2016 ME paper (Set 3), IISc Bangalore. Solutions by PARIXO AI. All 65 questions of this paper.