GATE 2017 ME Set 1 · Question 6
For steady flow of a viscous incompressible fluid through a circular pipe of constant diameter, the average velocity in the fully developed region is constant. Which one of the following statements about the average velocity in the developing region is TRUE?
- A
It increases until the flow is fully developed.
- B
It is constant and is equal to the average velocity in the fully developed region.
- C
It decreases until the flow is fully developed.
- D
It is constant but is always lower than the average velocity in the fully developed region.
GATE 2017 · Mechanical Engineering · Set 1 · IIT Roorkee
Answer
From the official answer key published by IIT Roorkee.
Worked solution
For steady flow of an incompressible fluid () through a circular pipe of constant cross-sectional area , the principle of conservation of mass states:
Since density and cross-sectional area are constant along the entire length of the pipe (both in the hydrodynamic entrance/developing region and in the fully developed region), the average velocity must also remain constant everywhere:
While the velocity profile changes from uniform at the inlet to parabolic in the fully developed region, the section-averaged velocity does not vary along the flow direction. Thus, options (A), (C), and (D) are incorrect.
Answer: (B) It is constant and is equal to the average velocity in the fully developed region.
Practise Fluid kinematics
28 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Fluid kinematics
- GATE 2017 ME Set 1 · Q7Consider the two-dimensional velocity field given by V = (5 + a1x + b1y) i + (4 + a2x + b2y) j, where a1,…
- GATE 2017 ME Set 1 · Q32For a steady flow, the velocity field is V = (-x2 + 3y) + (2xy) . The magnitude of the acceleration of a…
- GATE 2016 ME Set 2 · Q23The volumetric flow rate (per unit depth) between two streamlines having stream functions 1 and 2 is
- GATE 2016 ME Set 3 · Q23A channel of width 450 mm branches into two sub-channels having width 300 mm and 200 mm as shown in figure.…
- GATE 2016 ME Set 3 · Q24For a certain two-dimensional incompressible flow, velocity field is given by 2xy - y2 . The streamlines for…
- GATE 2016 ME Set 3 · Q51For a two-dimensional flow, the velocity field is u = x/x2 + y2 i + y/x2 + y2 j, where i and j are the basis…
Question from the official GATE 2017 ME paper (Set 1), IIT Roorkee. Solutions by PARIXO AI. All 65 questions of this paper.