GATE 2018 ME Set 2 · Question 15
The minimum axial compressive load, , required to initiate buckling for a pinned-pinned slender column with bending stiffness and length is
- A
- B
- C
- D
GATE 2018 · Mechanical Engineering · Set 2 · IIT Guwahati · printed as Q.5 in the ME section
Answer
From the official answer key published by IIT Guwahati.
Worked solution
According to Euler's buckling theory, the critical axial compressive load for an ideal slender column is given by:
where is the flexural rigidity and is the effective length of the column depending on its end boundary conditions.
For a pinned-pinned (hinged at both ends) column, the effective length is equal to its actual length:
Substituting into Euler's formula:
For comparison:
- Both ends fixed: (Option D).
- One end fixed, one end free: (Option A).
Answer: (B)
Practise Euler's Theory of Columns
10 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Euler's Theory of Columns
- GATE 2017 ME Set 1 · Q39An initially stress-free massless elastic beam of length L and circular cross-section with diameter d (d L)…
- GATE 2015 ME Set 1 · Q27Consider a steel (Young's modulus E = 200 GPa) column hinged on both sides. Its height is 1.0 m and…
- GATE 2012 ME · Q23For a long slender column of uniform cross section, the ratio of critical buckling load for the case with…
- GATE 2022 ME Set 1 · Q16A uniform light slender beam AB of section modulus EI is pinned by a frictionless joint A to the ground and…
- GATE 2021 ME Set 2 · Q34A column with one end fixed and one end free has a critical buckling load of 100 N. For the same column, if…
- GATE 2020 ME Set 1 · Q40The truss shown in the figure has four members of length l and flexural rigidity EI, and one member of…
Question from the official GATE 2018 ME paper (Set 2), IIT Guwahati. Solutions by PARIXO AI. All 65 questions of this paper.