GATE 2012 ME · Question 23
For a long slender column of uniform cross section, the ratio of critical buckling load for the case with both ends clamped to the case with both ends hinged is
- A
1
- B
2
- C
4
- D
8
GATE 2012 · Mechanical Engineering · IIT Delhi
Answer
No official key survives for this paper; this is PARIXO AI's own answer, not official.
Worked solution
According to Euler's buckling formula, the critical buckling load of a column is given by:
where is the effective length of the column.
1. For both ends hinged (pinned):
2. For both ends clamped (fixed):
Taking the ratio of the critical load for the clamped case to that for the hinged case:
Answer: (C)
Practise Euler's Theory of Columns
10 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Euler's Theory of Columns
- GATE 2022 ME Set 1 · Q16A uniform light slender beam AB of section modulus EI is pinned by a frictionless joint A to the ground and…
- GATE 2021 ME Set 2 · Q34A column with one end fixed and one end free has a critical buckling load of 100 N. For the same column, if…
- GATE 2020 ME Set 1 · Q40The truss shown in the figure has four members of length l and flexural rigidity EI, and one member of…
- GATE 2020 ME Set 2 · Q48Uniaxial compression test data for a solid metal bar of length 1 m is shown in the figure. The bar material…
- GATE 2019 ME Set 1 · Q50Consider a prismatic straight beam of length L = π m, pinned at the two ends as shown in the figure. The…
- GATE 2018 ME Set 1 · Q29A steel column of rectangular section (15 mm × 10 mm) and length 1.5 m is simply supported at both ends.…
Question from the official GATE 2012 ME paper, IIT Delhi. Solutions by PARIXO AI. All 65 questions of this paper.