GATE 2018 ME Set 2 · Question 18
Pre-tensioning of a bolted joint is used to
- A
strain harden the bolt head
- B
decrease stiffness of the bolted joint
- C
increase stiffness of the bolted joint
- D
prevent yielding of the thread root
GATE 2018 · Mechanical Engineering · Set 2 · IIT Guwahati · printed as Q.8 in the ME section
Answer
From the official answer key published by IIT Guwahati.
Worked solution
Pre-tensioning (or preloading) of a bolted joint places the bolt in initial tension and the clamped members in compression.
When an external tensile load is applied, the joint behaves as two springs in parallel (the bolt and the clamped members). The effective overall stiffness resisting external separation is the combined stiffness:
Because the preloaded clamped members remain in compression until joint separation, the effective joint stiffness is significantly higher than that of an un-preloaded joint (where only the bolt resists the load, ). This increased stiffness also reduces the proportion of external cyclic load transmitted to the bolt, dramatically enhancing fatigue life and preventing joint separation.
Answer: (C) increase stiffness of the bolted joint
Practise Riveted & Bolted Joints
13 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Riveted & Bolted Joints
- GATE 2017 ME Set 1 · Q19Consider the schematic of a riveted lap joint subjected to tensile load F, as shown below. Let d be the…
- GATE 2017 ME Set 2 · Q35A steel plate, connected to a fixed channel using three identical bolts A, B and C, carries a load of 6 kN…
- GATE 2016 ME Set 3 · Q48A bolted joint has four bolts arranged as shown in figure. The cross sectional area of each bolt is 25 mm2.…
- GATE 2015 ME Set 1 · Q56A horizontal plate has been joined to a vertical post using four rivets arranged as shown in the figure. The…
- GATE 2015 ME Set 3 · Q58A cantilever bracket is bolted to a column using three M12×1.75 bolts P, Q and R. The value of maximum shear…
- GATE 2014 ME Set 2 · Q42For the three bolt system shown in the figure, the bolt material has shear yield strength of 200 MPa. For a…
Question from the official GATE 2018 ME paper (Set 2), IIT Guwahati. Solutions by PARIXO AI. All 65 questions of this paper.