GATE 2019 ME Set 1 · Question 15
A flat-faced follower is driven using a circular eccentric cam rotating at a constant angular velocity . At time , the vertical position of the follower is , and the system is in the configuration shown below.
The vertical position of the follower face, is given by
- A
- B
- C
- D
GATE 2019 · Mechanical Engineering · Set 1 · IIT Madras · printed as Q.5 in the ME section
Answer
From the official answer key published by IIT Madras.
Worked solution
For a flat-faced follower contacting a circular eccentric cam of radius and eccentricity , the follower surface is always horizontal and tangent to the top of the circle. Thus, the vertical position of the follower face depends directly on the vertical coordinate of the cam's geometric center.
Let the pivot point be the origin . At , the center of the circular cam is at its lowest position, located vertically at distance below the pivot:
The height of the follower face is:
As the cam rotates at a constant angular velocity , the angle turned is . The vertical coordinate of the center of the cam at time is:
The vertical position of the follower face is therefore:
Given that the displacement , the position relative to the initial state is:
Answer: (C)
Practise Cams and Followers
4 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Cams and Followers
- GATE 2018 ME Set 2 · Q42In a cam-follower, the follower rises by h as the cam rotates by δ (radians) at constant angular velocity ω…
- GATE 2014 ME Set 3 · Q46Consider a rotating disk cam and a translating roller follower with zero offset. Which one of the following…
- GATE 2020 ME Set 1 · Q48A cam with a translating flat-face follower is desired to have the follower motion y(θ) = 4 [2πθ - θ2 ], 0 ≤…
Question from the official GATE 2019 ME paper (Set 1), IIT Madras. Solutions by PARIXO AI. All 65 questions of this paper.