GATE 2020 ME Set 1 · Question 48
A cam with a translating flat-face follower is desired to have the follower motion
Contact stress considerations dictate that the radius of curvature of the cam profile should not be less than 40 mm anywhere. The minimum permissible base circle radius is ____________ mm (*round off to one decimal place*).
GATE 2020 · Mechanical Engineering · Set 1 · IIT Delhi · printed as Q.38 in the ME section
Answer
From the official answer key published by IIT Delhi.
Worked solution
For a cam with a translating flat-face follower, the radius of curvature of the cam profile at any cam angle is given by:
where is the base circle radius.
The displacement is given as:
Differentiating with respect to :
Substituting into the expression for :
In the range , the minimum of occurs at the boundaries and , where . Hence, the minimum radius of curvature is:
Given :
Answer: 48
Practise Cams and Followers
4 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Cams and Followers
- GATE 2019 ME Set 1 · Q15A flat-faced follower is driven using a circular eccentric cam rotating at a constant angular velocity ω. At…
- GATE 2018 ME Set 2 · Q42In a cam-follower, the follower rises by h as the cam rotates by δ (radians) at constant angular velocity ω…
- GATE 2014 ME Set 3 · Q46Consider a rotating disk cam and a translating roller follower with zero offset. Which one of the following…
Question from the official GATE 2020 ME paper (Set 1), IIT Delhi. Solutions by PARIXO AI. All 65 questions of this paper.