GATE 2019 ME Set 1 · Question 42
The wall of a constant diameter pipe of length is heated uniformly with flux by wrapping a heater coil around it. The flow at the inlet to the pipe is hydrodynamically fully developed. The fluid is incompressible and the flow is assumed to be laminar and steady all through the pipe. The bulk temperature of the fluid is equal to at the inlet and at the exit. The wall temperatures are measured at three locations, P, Q and R, as shown in the figure. The flow thermally develops after some distance from the inlet. The following measurements are made:
| Point | P | Q | R |
| :--- | :--- | :--- | :--- |
| Wall Temp () | 50 | 80 | 90 |
Among the locations P, Q and R, the flow is thermally developed at
- A
P, Q and R
- B
P and Q only
- C
Q and R only
- D
R only
GATE 2019 · Mechanical Engineering · Set 1 · IIT Madras · printed as Q.32 in the ME section
Answer
From the official answer key published by IIT Madras.
Worked solution
For steady, incompressible flow with uniform wall heat flux in a circular pipe:
- By global energy balance, the mean (bulk) fluid temperature increases linearly with axial distance :
Given , , and :
From the figure, the axial locations are:
In the thermally fully developed region, the heat transfer coefficient is constant, which requires the temperature difference :
- At P:
- At Q:
- At R:
Since is constant between Q and R, the flow is thermally fully developed at Q and R only.
Answer: (C) Q and R only
Practise External & Internal Forced Convection Correlations
14 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from External & Internal Forced Convection Correlations
- GATE 2015 ME Set 1 · Q57For flow through a pipe of radius R, the velocity and temperature distribution are as follows: u(r, x) = C1…
- GATE 2014 ME Set 1 · Q24Consider a two-dimensional laminar flow over a long cylinder as shown in the figure below. The free stream…
- GATE 2014 ME Set 2 · Q22For laminar forced convection over a flat plate, if the free stream velocity increases by a factor of 2, the…
- GATE 2014 ME Set 4 · Q55Water flows through a tube of diameter 25 mm at an average velocity of 1.0 m/s. The properties of water are…
- GATE 2013 ME · Q50Common Data for Questions 50 and 51: Water (specific heat, cp = 4.18 kJ/kgK) enters a pipe at a rate of 0.01…
- GATE 2013 ME · Q51Common Data for Questions 50 and 51: Water (specific heat, cp = 4.18 kJ/kgK) enters a pipe at a rate of 0.01…
Question from the official GATE 2019 ME paper (Set 1), IIT Madras. Solutions by PARIXO AI. All 65 questions of this paper.