GATE 2013 ME · Question 50
Common Data for Questions 50 and 51:
Water (specific heat, ) enters a pipe at a rate of and a temperature of . The pipe, of diameter and length , is subjected to a wall heat flux in :
If , where is in and in the direction of flow ( at the inlet), the bulk mean temperature of the water leaving the pipe in is
- A
42
- B
62
- C
74
- D
104
GATE 2013 · Mechanical Engineering · IIT Bombay
Answer
From the official answer key published by IIT Bombay.
Worked solution
The total rate of heat transfer to the water over the pipe length is found by integrating the wall heat flux over the inner surface area:
Given and :
Applying the overall energy balance for the fluid flow:
Given , , and inlet bulk temperature :
Answer: (B) 62
Practise External & Internal Forced Convection Correlations
14 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from External & Internal Forced Convection Correlations
- GATE 2013 ME · Q51Common Data for Questions 50 and 51: Water (specific heat, cp = 4.18 kJ/kgK) enters a pipe at a rate of 0.01…
- GATE 2025 ME · Q51Water enters a tube of diameter, D = 60 mm with mass flow rate of 0.01 kg s-1 as shown in the figure below.…
- GATE 2024 ME · Q18Consider incompressible laminar flow over a flat plate with freestream velocity of u . The Nusselt number…
- GATE 2024 ME · Q19Consider a hydrodynamically fully developed laminar flow through a circular pipe with the flow along the…
- GATE 2023 ME · Q21Consider incompressible laminar flow of a constant property Newtonian fluid in an isothermal circular tube.…
- GATE 2022 ME Set 2 · Q65Consider a hydrodynamically and thermally fully-developed, steady fluid flow of 1 kg/s in a uniformly heated…
Question from the official GATE 2013 ME paper, IIT Bombay. Solutions by PARIXO AI. All 65 questions of this paper.