PARIXO GATE · ME Open the app

GATE 2019 ME Set 2 · Question 40

2 marksMultiple choiceMechanics of MaterialsCombined Loading and Bending of Curved Bars

Consider two concentric circular cylinders of different materials and in contact with each other at , as shown below. The interface at is frictionless. The composite cylinder system is subjected to internal pressure . Let and denote the radial and tangential displacement and stress components, respectively, in material . Similarly, and denote the radial and tangential displacement and stress components, respectively, in material . The boundary conditions that need to be satisfied at the frictionless interface between the two cylinders are:

Figure 1 for GATE 2019 ME Set 2 question 40
  1. A

  2. B

  3. C

  4. D

GATE 2019 · Mechanical Engineering · Set 2 · IIT Madras · printed as Q.30 in the ME section

Answer
(A)

From the official answer key published by IIT Madras.

Worked solution

At the contact interface between the two concentric cylinders:
1. Kinematic continuity (displacement): To prevent separation or penetration of the two materials, the radial displacement must be continuous:

Because the interface is explicitly stated to be frictionless, relative sliding can occur freely in the tangential direction without any shear resistance (). Thus, the tangential displacements and do not have to be equal.

2. Equilibrium (tractions): By Newton's third law, the normal contact pressure must be equal and opposite on the two surfaces, which requires continuity of the radial stress:

On the other hand, the hoop stress acts parallel to the interface and depends on the differing elastic moduli of materials and ; therefore, it exhibits a jump discontinuity across the interface ($sigma_{\theta\theta}^M
eq sigma_{\theta\theta}^N$).

Hence, the only required interface boundary conditions are and .

Answer: (A)

Practise Combined Loading and Bending of Curved Bars

2 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.

More from Combined Loading and Bending of Curved Bars

Question from the official GATE 2019 ME paper (Set 2), IIT Madras. Solutions by PARIXO AI. All 65 questions of this paper.