GATE 2019 ME Set 2 · Question 41
A prismatic, straight, elastic, cantilever beam is subjected to a linearly distributed transverse load as shown below. If the beam length is , Young's modulus , and area moment of inertia , the magnitude of the maximum deflection is
- A
- B
- C
- D
GATE 2019 · Mechanical Engineering · Set 2 · IIT Madras · printed as Q.31 in the ME section
Answer
From the official answer key published by IIT Madras.
Worked solution
Consider the coordinate measured from the free end towards the fixed end, so the free end is at and the fixed end at . The load intensity at a distance from the free end is acting downwards.
The bending moment at any cross-section is:
Using the Euler-Bernoulli beam equation :
Integrating with respect to :
Applying the boundary conditions at the clamped end ():
1. Zero slope,
2. Zero deflection,
The maximum deflection occurs at the free end ():
Answer: (B)
Practise Deflection of Beams
15 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Deflection of Beams
- GATE 2019 ME Set 2 · Q47A horizontal cantilever beam of circular cross-section, length 1.0 m and flexural rigidity EI = 200 N×m2 is…
- GATE 2016 ME Set 1 · Q19A cantilever beam having square cross-section of side a is subjected to an end load. If a is increased by…
- GATE 2016 ME Set 2 · Q43A simply supported beam of length 2L is subjected to a moment M at the mid-point x = 0 as shown in the…
- GATE 2016 ME Set 3 · Q45A beam of length L is carrying a uniformly distributed load w per unit length. The flexural rigidity of the…
- GATE 2015 ME Set 1 · Q54A cantilever beam with flexural rigidity of 200 N.m2 is loaded as shown in the figure. The deflection (in…
- GATE 2015 ME Set 2 · Q43A cantilever beam with square cross-section of 6 mm side is subjected to a load of 2 kN normal to the top…
Question from the official GATE 2019 ME paper (Set 2), IIT Madras. Solutions by PARIXO AI. All 65 questions of this paper.