GATE 2020 ME Set 1 · Question 30
1 markNumerical answerTheory of MachinesFlywheels and Turning Moment Diagrams
A flywheel is attached to an engine to keep its rotational speed between 100 rad/s and 110 rad/s. If the energy fluctuation in the flywheel between these two speeds is 1.05 kJ then the moment of inertia of the flywheel is _______ kg.m
(round off to 2 decimal places).
GATE 2020 · Mechanical Engineering · Set 1 · IIT Delhi · printed as Q.20 in the ME section
Answer
0.98 to 1.02
From the official answer key published by IIT Delhi.
Worked solution
The maximum fluctuation of energy in a flywheel is given by:
where:
- is the mass moment of inertia of the flywheel.
Substituting the given values:
Answer: 1
Practise Flywheels and Turning Moment Diagrams
10 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Flywheels and Turning Moment Diagrams
- GATE 2020 ME Set 2 · Q49The turning moment diagram of a flywheel fitted to a fictitious engine is shown in the figure. The mean…
- GATE 2015 ME Set 3 · Q12For the same material and the mass, which of the following configurations of flywheel will have maximum mass…
- GATE 2015 ME Set 3 · Q57The torque (in N-m) exerted on the crank shaft of a two stroke engine can be described as T = 10000 + 1000…
- GATE 2014 ME Set 2 · Q47Maximum fluctuation of kinetic energy in an engine has been calculated to be 2600 J. Assuming that the…
- GATE 2014 ME Set 4 · Q48Torque and angular speed data over one cycle for a shaft carrying a flywheel are shown in the figures. The…
- GATE 2013 ME · Q31A flywheel connected to a punching machine has to supply energy of 400 Nm while running at a mean angular…
Question from the official GATE 2020 ME paper (Set 1), IIT Delhi. Solutions by PARIXO AI. All 65 questions of this paper.