GATE 2014 ME Set 4 · Question 48
Torque and angular speed data over one cycle for a shaft carrying a flywheel are shown in the figures. The moment of inertia (in ) of the flywheel is _______
GATE 2014 · Mechanical Engineering · Set 4 · IIT Kharagpur · printed as Q.38 in the ME section
Answer
From the official answer key published by IIT Kharagpur.
Worked solution
The work done by the torque on the flywheel is equal to the change in its rotational kinetic energy:
From the torque and angular speed plots, consider the interval from to :
- The torque is constant:
- The initial angular speed at is
- The final angular speed at is
The work done during this interval is the area under the - diagram:
Equating this to the change in kinetic energy:
Answer: 31.42
Practise Flywheels and Turning Moment Diagrams
10 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Flywheels and Turning Moment Diagrams
- GATE 2013 ME · Q31A flywheel connected to a punching machine has to supply energy of 400 Nm while running at a mean angular…
- GATE 2012 ME · Q21A circular solid disc of uniform thickness 20 mm, radius 200 mm and mass 20 kg, is used as a flywheel. If it…
- GATE 2024 ME · Q23The change in kinetic energy Δ E of an engine is 300 J, and minimum and maximum shaft speeds are ωmin = 220…
- GATE 2021 ME Set 2 · Q64The torque provided by an engine is given by T(θ) = 12000 + 2500 (2θ) N.m, where θ is the angle turned by…
- GATE 2020 ME Set 1 · Q30A flywheel is attached to an engine to keep its rotational speed between 100 rad/s and 110 rad/s. If the…
- GATE 2020 ME Set 2 · Q49The turning moment diagram of a flywheel fitted to a fictitious engine is shown in the figure. The mean…
Question from the official GATE 2014 ME paper (Set 4), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.