GATE 2021 ME Set 2 · Question 26
The controlling force curves P, Q and R for a spring controlled governor are shown in the figure, where and are any two radii of rotation.
The characteristics shown by the curves are
- A
P – Unstable; Q – Stable; R – Isochronous
- B
P – Unstable; Q – Isochronous; R – Stable
- C
P– Stable; Q – Isochronous; R – Unstable
- D
P – Stable; Q – Unstable; R – Isochronous
GATE 2021 · Mechanical Engineering · Set 2 · IIT Bombay · printed as Q.16 in the ME section
Answer
From the official answer key published by IIT Bombay.
Worked solution
For a spring-controlled governor, the controlling force is related to the radius of rotation by the linear equation:
The equilibrium speed is given by , which implies:
1. Curve P (, positive intercept on force axis):
As increases, decreases, so the equilibrium speed decreases with an increase in radius. This represents an unstable governor.
2. Curve Q (, passes through the origin):
for all radii of rotation. This represents an isochronous governor.
3. Curve R (, negative intercept on force axis / positive intercept on radius axis):
As increases, increases with an increase in radius. This represents a stable governor.
Answer: (B) P – Unstable; Q – Isochronous; R – Stable
Practise Centrifugal Governors
2 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Centrifugal Governors
Question from the official GATE 2021 ME paper (Set 2), IIT Bombay. Solutions by PARIXO AI. All 65 questions of this paper.