GATE 2021 ME Set 2 · Question 25
Consider the mechanism shown in the figure. There is rolling contact without slip between the disc and ground.
Select the correct statement about instantaneous centers in the mechanism.
- A
Only points , , and are instantaneous centers of mechanism
- B
Only points , , and are instantaneous centers of mechanism
- C
Only points , , , , and are instantaneous centers of mechanism
- D
All points , , , , and are instantaneous centers of mechanism
GATE 2021 · Mechanical Engineering · Set 2 · IIT Bombay · printed as Q.15 in the ME section
Answer
From the official answer key published by IIT Bombay.
Worked solution
The mechanism consists of links:
1. Fixed ground (link 1)
2. Crank (link 2)
3. Connecting rod (link 3)
4. Rolling disc (link 4)
The total number of instantaneous centers is given by:
By direct inspection:
- is at pin joint
- is at pin joint
- is at pin joint
- is at the instantaneous point of contact between the disc and the ground, point (pure rolling)
Using Kennedy's theorem of three centers:
- must lie at the intersection of line (line ) and line (line ), which is point .
- must lie at the intersection of line (horizontal line through and ) and line (line ), which is point .
Hence, all six points and are the instantaneous centers of the mechanism.
Answer: (D) All points , , , , and are instantaneous centers of mechanism
Practise Velocity and Acceleration Analysis
17 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Velocity and Acceleration Analysis
- GATE 2019 ME Set 1 · Q40In a four bar planar mechanism shown in the figure, AB = 5 cm, AD = 4 cm and DC = 2 cm. In the configuration…
- GATE 2019 ME Set 2 · Q46The crank of a slider-crank mechanism rotates counter-clockwise (CCW) with a constant angular velocity ω, as…
- GATE 2019 ME Set 2 · Q49A four bar mechanism is shown in the figure. The link numbers are mentioned near the links. Input link 2 is…
- GATE 2017 ME Set 1 · Q47For an inline slider-crank mechanism, the lengths of the crank and connecting rod are 3 m and 4 m,…
- GATE 2017 ME Set 2 · Q12In a slider-crank mechanism, the lengths of the crank and the connecting rod are 100 mm and 160 mm,…
- GATE 2017 ME Set 2 · Q30Block 2 slides outward on link 1 at a uniform velocity of 6 m/s as shown in the figure. Link 1 is rotating…
Question from the official GATE 2021 ME paper (Set 2), IIT Bombay. Solutions by PARIXO AI. All 65 questions of this paper.