GATE 2022 ME Set 1 · Question 30
The figure shows a purely convergent nozzle with a steady, inviscid compressible flow of an ideal gas with constant thermophysical properties operating under choked condition. The exit plane shown in the figure is located within the nozzle. If the inlet pressure () is increased while keeping the back pressure () unchanged, which of the following statements is/are true?
- A
Mass flow rate through the nozzle will remain unchanged.
- B
Mach number at the exit plane of the nozzle will remain unchanged at unity.
- C
Mass flow rate through the nozzle will increase.
- D
Mach number at the exit plane of the nozzle will become more than unity.
GATE 2022 · Mechanical Engineering · Set 1 · IIT Kharagpur
Answer
From the official answer key published by IIT Kharagpur.
Worked solution
In a purely convergent nozzle, the minimum cross-sectional area occurs at the exit plane (throat). When the nozzle is operating under choked conditions:
1. Mach number: The maximum Mach number achievable at the exit of a purely convergent nozzle is unity (). Even if the inlet stagnation pressure increases (further lowering below the critical pressure ratio), the flow cannot expand supersonically within a converging section. Thus, the Mach number at the exit remains fixed at . Hence, (B) is true and (D) is false.
2. Mass flow rate: The choked mass flow rate through a nozzle of exit area is given by:
Since , increasing the inlet total pressure directly increases the mass flow rate. Hence, (C) is true and (A) is false.
Answer: (B) Mach number at the exit plane of the nozzle will remain unchanged at unity.; (C) Mass flow rate through the nozzle will increase.
Practise Compressible flow basics
6 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Compressible flow basics
- GATE 2022 ME Set 2 · Q24Consider a steady flow through a horizontal divergent channel, as shown in the figure, with supersonic flow…
- GATE 2021 ME Set 2 · Q33An object is moving with a Mach number of 0.6 in an ideal gas environment, which is at a temperature of 350…
- GATE 2026 ME · Q25An ideal gas passes isothermally through a long horizontal uniform cross-section pipe under steady flow.…
- GATE 2024 ME · Q40Steady, compressible flow of air takes place through an adiabatic converging-diverging nozzle, as shown in…
- GATE 2023 ME · Q20Consider an isentropic flow of air (ratio of specific heats = 1.4) through a duct as shown in the figure.…
Question from the official GATE 2022 ME paper (Set 1), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.