GATE 2022 ME Set 1 · Question 37
An L-shaped elastic member ABC with slender arms AB and BC of uniform cross-section is clamped at end A and connected to a pin at end C. The pin remains in continuous contact with and is constrained to move in a smooth horizontal slot. The section modulus of the member is same in both the arms. The end C is subjected to a horizontal force and all the deflections are in the plane of the figure. Given the length AB is and length BC is , the magnitude and direction of the normal force on the pin from the slot, respectively, are
- A
, and downwards
- B
, and upwards
- C
, and downwards
- D
, and upwards
GATE 2022 · Mechanical Engineering · Set 1 · IIT Kharagpur
Answer
From the official answer key published by IIT Kharagpur.
Worked solution
Let a vertical reaction force act on the pin at end C. Since the pin is constrained to move along a horizontal slot, the vertical displacement at C is zero, i.e., .
Taking as acting vertically upward and applying Castigliano's theorem:
- For member BC (length , vertical from at C to at B):
The axial load is and the bending moment at height is .
- For member AB (length , horizontal from at B to at A):
The bending moment at distance from B is .
Neglecting axial strain energy for the slender member, the total strain energy is:
Setting the vertical deflection at C to zero:
The negative sign indicates that the reaction force from the slot on the pin acts downwards with a magnitude of .
Answer: (A) , and downwards
Practise Energy Methods and Theories of Failure
21 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Energy Methods and Theories of Failure
- GATE 2022 ME Set 2 · Q18A structural member under loading has a uniform state of plane stress which in usual notations is given by…
- GATE 2021 ME Set 2 · Q27The von Mises stress at a point in a body subjected to forces is proportional to the square root of the
- GATE 2021 ME Set 2 · Q41A plane frame PQR (fixed at P and free at R) is shown in the figure. Both members (PQ and QR) have length,…
- GATE 2020 ME Set 1 · Q38Bars of square and circular cross-section with 0.5 m length are made of a material with shear strength of 20…
- GATE 2017 ME Set 1 · Q21In a metal forming operation when the material has just started yielding, the principal stresses are σ1 =…
- GATE 2017 ME Set 1 · Q40A point mass of 100 kg is dropped onto a massless elastic bar (cross-sectional area = 100 mm2, length = 1 m,…
Question from the official GATE 2022 ME paper (Set 1), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.