GATE 2013 ME · Question 32
A compound gear train with gears P, Q, R and S has number of teeth , , and , respectively. Gears Q and R are mounted on the same shaft as shown in the figure below. The diameter of the gear Q is twice that of the gear R. If the module of the gear R is , the center distance in between gears P and S is
- A
- B
- C
- D
GATE 2013 · Mechanical Engineering · IIT Bombay
Answer
From the official answer key published by IIT Bombay.
Worked solution
Given the teeth counts: , , , and .
For gear R, the module is , so its pitch diameter is:
Since the diameter of gear Q is twice that of gear R:
The module of gear Q is:
For mating gears, the modules must match:
- Gear P meshes with Q, so :
- Gear S meshes with R, so :
Because gears Q and R share the same shaft and all centers lie along a straight line:
Answer: (B)
Practise Gears and Gear Trains
20 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Gears and Gear Trains
- GATE 2012 ME · Q8The following are the data for two crossed helical gears used for speed reduction: Gear I : Pitch circle…
- GATE 2026 ME · Q17A gear train with five gears is shown in the figure below. The number of teeth on each gear is N1, N2, N3,…
- GATE 2026 ME · Q22Worm gearsets are used for transmitting rotary motion between
- GATE 2024 ME · Q52The Levai type-A train illustrated in the figure has gears with module m = 8 mm/tooth. Gears 2 and 3 have 19…
- GATE 2023 ME · Q29Two meshing spur gears 1 and 2 with diametral pitch of 8 teeth per mm and an angular velocity ratio…
- GATE 2022 ME Set 1 · Q53A schematic of an epicyclic gear train is shown in the figure. The sun (gear 1) and planet (gear 2) are…
Question from the official GATE 2013 ME paper, IIT Bombay. Solutions by PARIXO AI. All 65 questions of this paper.