GATE 2026 ME · Question 22
Worm gearsets are used for transmitting rotary motion between
- A
intersecting shafts
- B
parallel shafts
- C
non-parallel and non-intersecting shafts
- D
non-parallel and intersecting shafts
GATE 2026 · Mechanical Engineering · IIT Guwahati
Answer
From the official answer key published by IIT Guwahati.
Worked solution
Gears are classified based on the relative orientation of their axes of rotation:
- Parallel shafts: Spur gears, helical gears, herringbone gears.
- Intersecting shafts: Straight bevel gears, spiral bevel gears.
- Non-parallel and non-intersecting (skew) shafts: Worm gearsets, hypoid gears, crossed helical gears.
A worm gearset consists of a worm (resembling a screw) and a worm wheel (gear), which operate on axes that are perpendicular but do not intersect, allowing high reduction ratios in a compact space.
Answer: (C) non-parallel and non-intersecting shafts
Practise Gears and Gear Trains
20 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Gears and Gear Trains
- GATE 2024 ME · Q52The Levai type-A train illustrated in the figure has gears with module m = 8 mm/tooth. Gears 2 and 3 have 19…
- GATE 2023 ME · Q29Two meshing spur gears 1 and 2 with diametral pitch of 8 teeth per mm and an angular velocity ratio…
- GATE 2022 ME Set 1 · Q53A schematic of an epicyclic gear train is shown in the figure. The sun (gear 1) and planet (gear 2) are…
- GATE 2021 ME Set 2 · Q42A power transmission mechanism consists of a belt drive and a gear train as shown in the figure. Diameters…
- GATE 2020 ME Set 2 · Q39The sun (S) and the planet (P) of an epicyclic gear train shown in the figure have identical number of…
- GATE 2019 ME Set 2 · Q17A spur gear has pitch circle diameter D and number of teeth T. The circular pitch of the gear is
Question from the official GATE 2026 ME paper, IIT Guwahati. Solutions by PARIXO AI. All 65 questions of this paper.