GATE 2013 ME · Question 34
Two cutting tools are being compared for a machining operation. The tool life equations are:
where is the cutting speed in and is the tool life in . The carbide tool will provide higher tool life if the cutting speed in exceeds
- A
- B
- C
- D
GATE 2013 · Mechanical Engineering · IIT Bombay
Answer
From the official answer key published by IIT Bombay.
Worked solution
The tool life equations for the carbide and HSS tools are given by:
To find the cutting speed where both tools have the same tool life ():
Substituting back into either tool life equation to find the corresponding cutting speed :
Since the carbide tool has a higher Taylor exponent (), its tool life decreases less rapidly with speed relative to HSS at elevated speeds. Thus, for , the carbide tool provides a higher tool life than the HSS tool.
Answer: (B)
Practise Tool Wear, Tool Life and Machinability
12 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Tool Wear, Tool Life and Machinability
- GATE 2026 ME · Q64A drill bit during its lifetime can produce 150 through holes in a plate at a drill-speed of 200 RPM. If the…
- GATE 2024 ME · Q60A cutting tool provides a tool life of 60 minutes while machining with the cutting speed of 60 m/min. When…
- GATE 2019 ME Set 1 · Q63Taylor's tool life equation is given by VTn = C, where V is in m/min and T is in min. In a turning…
- GATE 2018 ME Set 1 · Q23Using the Taylor's tool life equation with exponent n = 0.5, if the cutting speed is reduced by 50%, the…
- GATE 2018 ME Set 2 · Q59Taylor's tool life equation is used to estimate the life of a batch of identical HSS twist drills by…
- GATE 2017 ME Set 1 · Q55Two cutting tools with tool life equations given below are being compared: Tool 1: VT0.1 = 150 Tool 2: VT0.3…
Question from the official GATE 2013 ME paper, IIT Bombay. Solutions by PARIXO AI. All 65 questions of this paper.