GATE 2018 ME Set 1 · Question 23
Using the Taylor's tool life equation with exponent , if the cutting speed is reduced by , the ratio of new tool life to original tool life is
- A
4
- B
2
- C
1
- D
0.5
GATE 2018 · Mechanical Engineering · Set 1 · IIT Guwahati · printed as Q.13 in the ME section
Answer
From the official answer key published by IIT Guwahati.
Worked solution
According to Taylor's tool life equation:
where is the cutting speed, is the tool life, is the tool life exponent, and is a constant.
Given:
- Exponent
- New cutting speed
Equating for both cutting conditions:
Substitute the given values:
Thus, the ratio of new tool life to original tool life is .
Answer: (A) 4
Practise Tool Wear, Tool Life and Machinability
12 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Tool Wear, Tool Life and Machinability
- GATE 2018 ME Set 2 · Q59Taylor's tool life equation is used to estimate the life of a batch of identical HSS twist drills by…
- GATE 2017 ME Set 1 · Q55Two cutting tools with tool life equations given below are being compared: Tool 1: VT0.1 = 150 Tool 2: VT0.3…
- GATE 2017 ME Set 2 · Q54During the turning of a 20 mm-diameter steel bar at a spindle speed of 400 rpm, a tool life of 20 minute is…
- GATE 2016 ME Set 1 · Q60The tool life equation for HSS tool is VT0.14 f0.7 d0.4 = Constant. The tool life (T) of 30 min is obtained…
- GATE 2016 ME Set 3 · Q61In a single point turning operation with cemented carbide tool and steel work piece, it is found that the…
- GATE 2015 ME Set 1 · Q33Under certain cutting conditions, doubling the cutting speed reduces the tool life to (1/16 )th of the…
Question from the official GATE 2018 ME paper (Set 1), IIT Guwahati. Solutions by PARIXO AI. All 65 questions of this paper.