GATE 2017 ME Set 1 · Question 55
Two cutting tools with tool life equations given below are being compared:
Tool 1:
Tool 2:
where is cutting speed in m/minute and is tool life in minutes. The breakeven cutting speed beyond which Tool 2 will have a higher tool life is ________ m/minute.
GATE 2017 · Mechanical Engineering · Set 1 · IIT Roorkee
Answer
From the official answer key published by IIT Roorkee.
Worked solution
The Taylor's tool life equations are:
At the breakeven point, the cutting speed gives the same tool life for both tools ():
Dividing the second equation by the first:
Substituting into the first equation to find the breakeven cutting speed :
For cutting speeds , Tool 2 provides a longer tool life than Tool 1.
Answer: 106.07
Practise Tool Wear, Tool Life and Machinability
12 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Tool Wear, Tool Life and Machinability
- GATE 2017 ME Set 2 · Q54During the turning of a 20 mm-diameter steel bar at a spindle speed of 400 rpm, a tool life of 20 minute is…
- GATE 2016 ME Set 1 · Q60The tool life equation for HSS tool is VT0.14 f0.7 d0.4 = Constant. The tool life (T) of 30 min is obtained…
- GATE 2016 ME Set 3 · Q61In a single point turning operation with cemented carbide tool and steel work piece, it is found that the…
- GATE 2015 ME Set 1 · Q33Under certain cutting conditions, doubling the cutting speed reduces the tool life to (1/16 )th of the…
- GATE 2014 ME Set 3 · Q33Cutting tool is much harder than the workpiece. Yet the tool wears out during the tool-work interaction,…
- GATE 2013 ME · Q34Two cutting tools are being compared for a machining operation. The tool life equations are: aligned Carbide…
Question from the official GATE 2017 ME paper (Set 1), IIT Roorkee. Solutions by PARIXO AI. All 65 questions of this paper.