GATE 2013 ME · Question 49
Common Data for Questions 48 and 49:
A single riveted lap joint of two similar plates as shown in the figure below has the following geometrical and material details.
width of the plate , thickness of the plate , number of rivets , diameter of the rivet , diameter of the rivet hole , allowable tensile stress of the plate , allowable shear stress of the rivet and allowable bearing stress of the rivet .
If the plates are to be designed to avoid tearing failure, the maximum permissible load in is
- A
83
- B
125
- C
167
- D
501
GATE 2013 · Mechanical Engineering · IIT Bombay
Answer
From the official answer key published by IIT Bombay.
Worked solution
The tearing resistance of a plate in a riveted joint is determined across the weakest cross-section, which passes through the rivet holes.
The net tensile area of the plate along the row of rivet holes is:
Substitute the given values:
- Width of the plate,
- Number of rivets,
- Diameter of the rivet hole,
- Thickness of the plate,
To avoid tearing failure, the maximum permissible load is limited by the allowable tensile stress of the plate :
Using the rivet diameter instead of the hole diameter would incorrectly overestimate the tearing area, whereas taking for a single rivet hole pitch gives (option A) if one considers only part of the width.
Answer: (C) 167
Practise Riveted & Bolted Joints
13 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Riveted & Bolted Joints
- GATE 2022 ME Set 1 · Q18A square threaded screw is used to lift a load W by applying a force F. Efficiency of square threaded screw…
- GATE 2022 ME Set 1 · Q40A bracket is attached to a vertical column by means of two identical rivets U and V separated by a distance…
- GATE 2020 ME Set 1 · Q49A rectangular steel bar of length 500 mm, width 100 mm, and thickness 15 mm is cantilevered to a 200 mm…
- GATE 2018 ME Set 2 · Q18Pre-tensioning of a bolted joint is used to
- GATE 2017 ME Set 1 · Q19Consider the schematic of a riveted lap joint subjected to tensile load F, as shown below. Let d be the…
- GATE 2017 ME Set 2 · Q35A steel plate, connected to a fixed channel using three identical bolts A, B and C, carries a load of 6 kN…
Question from the official GATE 2013 ME paper, IIT Bombay. Solutions by PARIXO AI. All 65 questions of this paper.