GATE 2014 ME Set 4 · Question 21
Ball bearings are rated by a manufacturer for a life of revolutions. The catalogue rating of a particular bearing is 16 kN. If the design load is 2 kN, the life of the bearing will be revolutions, where is equal to ______
GATE 2014 · Mechanical Engineering · Set 4 · IIT Kharagpur · printed as Q.11 in the ME section
Answer
From the official answer key published by IIT Kharagpur.
Worked solution
The relationship between the dynamic load rating , the applied equivalent dynamic load , and the rated life (in millions of revolutions) for a rolling contact bearing is given by:
where for ball bearings and for roller bearings.
Given:
- Dynamic load capacity,
- Design load,
- Bearing type: ball bearing ()
Substituting the values:
Therefore, the life of the bearing is revolutions, which gives .
Answer: 512
Practise Rolling Contact Bearings
6 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Rolling Contact Bearings
- GATE 2025 ME · Q30A shaft carries a helical spur gear. Which one of the following bearings can NOT be used to support it?
- GATE 2024 ME · Q22For a ball bearing, the fatigue life in millions of revolutions is given by L = (C/P )n, where P is the…
- GATE 2018 ME Set 1 · Q42A self-aligning ball bearing has a basic dynamic load rating (C10, for 106 revolutions) of 35 kN. If the…
- GATE 2016 ME Set 3 · Q22Which of the bearings given below SHOULD NOT be subjected to a thrust load?
- GATE 2015 ME Set 3 · Q40For ball bearings, the fatigue life L measured in number of revolutions and the radial load F are related by…
Question from the official GATE 2014 ME paper (Set 4), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.