GATE 2024 ME · Question 22
For a ball bearing, the fatigue life in millions of revolutions is given by , where is the constant applied load and is the basic dynamic load rating. Which one of the following statements is TRUE?
- A
, assuming that the inner racing is fixed and outer racing is revolving
- B
, assuming that the inner racing is fixed and outer racing is revolving
- C
, assuming that the outer racing is fixed and inner racing is revolving
- D
, assuming that the outer racing is fixed and inner racing is revolving
GATE 2024 · Mechanical Engineering · IISc Bangalore
Answer
From the official answer key published by IISc Bangalore.
Worked solution
The rating life of a rolling contact bearing under a dynamic equivalent load is given by the Lundberg-Palmgren relation:
where is the basic dynamic load rating, and the life exponent depends on the type of rolling elements:
- For ball bearings (point contact):
- For roller bearings (line contact):
In standard bearing design formulas, the dynamic equivalent load is expressed as , where is the race rotation factor. The baseline rating condition assumes that the outer race is stationary (fixed) and the inner race is rotating (). If the outer ring rotates while the inner ring is fixed, higher stresses occur, requiring a race rotation factor .
Therefore, for a ball bearing, assuming that the outer race is fixed and the inner race is revolving.
Answer: (C) , assuming that the outer racing is fixed and inner racing is revolving
Practise Rolling Contact Bearings
6 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Rolling Contact Bearings
- GATE 2018 ME Set 1 · Q42A self-aligning ball bearing has a basic dynamic load rating (C10, for 106 revolutions) of 35 kN. If the…
- GATE 2016 ME Set 3 · Q22Which of the bearings given below SHOULD NOT be subjected to a thrust load?
- GATE 2015 ME Set 3 · Q40For ball bearings, the fatigue life L measured in number of revolutions and the radial load F are related by…
- GATE 2014 ME Set 4 · Q21Ball bearings are rated by a manufacturer for a life of 106 revolutions. The catalogue rating of a…
- GATE 2025 ME · Q30A shaft carries a helical spur gear. Which one of the following bearings can NOT be used to support it?
Question from the official GATE 2024 ME paper, IISc Bangalore. Solutions by PARIXO AI. All 65 questions of this paper.