GATE 2016 ME Set 3 · Question 22
1 markMultiple choiceMachine DesignRolling Contact Bearings
Which of the bearings given below SHOULD NOT be subjected to a thrust load?
- A
Deep groove ball bearing
- B
Angular contact ball bearing
- C
Cylindrical (straight) roller bearing
- D
Single row tapered roller bearing
GATE 2016 · Mechanical Engineering · Set 3 · IISc Bangalore · printed as Q.12 in the ME section
Answer
(C)
From the official answer key published by IISc Bangalore.
Worked solution
Rolling contact bearings are selected based on the type of load they can support:
- Deep groove ball bearings primarily carry radial loads, but can also carry a moderate amount of axial (thrust) load in both directions.
- Angular contact ball bearings are designed to support combined radial and substantial unidirectional thrust loads.
- Tapered roller bearings have rolling elements arranged along a conical surface, allowing them to support heavy radial and axial loads simultaneously.
- Cylindrical (straight) roller bearings have line contact parallel to the axis of rotation and cannot support axial (thrust) loads (except in special designs with guiding flanges that can support only light, intermittent thrust loads). Hence, standard cylindrical roller bearings should not be subjected to a thrust load.
Therefore, option (C) is the correct choice.
Answer: (C) Cylindrical (straight) roller bearing
Practise Rolling Contact Bearings
6 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Rolling Contact Bearings
- GATE 2015 ME Set 3 · Q40For ball bearings, the fatigue life L measured in number of revolutions and the radial load F are related by…
- GATE 2014 ME Set 4 · Q21Ball bearings are rated by a manufacturer for a life of 106 revolutions. The catalogue rating of a…
- GATE 2025 ME · Q30A shaft carries a helical spur gear. Which one of the following bearings can NOT be used to support it?
- GATE 2024 ME · Q22For a ball bearing, the fatigue life in millions of revolutions is given by L = (C/P )n, where P is the…
- GATE 2018 ME Set 1 · Q42A self-aligning ball bearing has a basic dynamic load rating (C10, for 106 revolutions) of 35 kN. If the…
Question from the official GATE 2016 ME paper (Set 3), IISc Bangalore. Solutions by PARIXO AI. All 65 questions of this paper.