GATE 2014 ME Set 4 · Question 26
Kaplan water turbine is commonly used when the flow through its runner is
- A
axial and the head available is more than 100 m
- B
axial and the head available is less than 10 m
- C
radial and the head available is more than 100 m
- D
mixed and the head available is about 50 m
GATE 2014 · Mechanical Engineering · Set 4 · IIT Kharagpur · printed as Q.16 in the ME section
Answer
From the official answer key published by IIT Kharagpur.
Worked solution
A Kaplan turbine is an axial-flow reaction turbine with adjustable runner blades and guide vanes.
- Flow direction: Water flows through the runner parallel to the axis of rotation, so it is strictly an axial flow turbine.
- Head and discharge requirements: Kaplan turbines are specially designed for low heads (typically , including heads less than ) and large volumetric flow rates (high discharge).
- By comparison, Pelton turbines are used for high head () with tangential flow, and Francis turbines are used for medium heads () with mixed/radial-to-axial flow.
Therefore, a Kaplan turbine is suited for axial flow and available heads less than .
Answer: (B) axial and the head available is less than 10 m
Practise Hydraulic Turbines (Pelton, Francis, Kaplan)
9 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Hydraulic Turbines (Pelton, Francis, Kaplan)
- GATE 2013 ME · Q18In order to have maximum power from a Pelton turbine, the bucket speed must be
- GATE 2026 ME · Q58An inward flow reaction turbine, having an outer diameter of 1 m, runs at 600 RPM. The normal component of…
- GATE 2025 ME · Q53Consider a Pelton wheel of 1 m diameter. The magnitude of relative velocity of water at the bucket inlet is…
- GATE 2021 ME Set 1 · Q58A single jet Pelton wheel operates at 300 rpm. The mean diameter of the wheel is 2 m. Operating head and…
- GATE 2021 ME Set 2 · Q59A vertical shaft Francis turbine rotates at 300 rpm. The available head at the inlet to the turbine is 200…
- GATE 2020 ME Set 1 · Q64For a Kaplan (axial flow) turbine, the outlet blade velocity diagram at a section is shown in figure. The…
Question from the official GATE 2014 ME paper (Set 4), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.