GATE 2014 ME Set 4 · Question 47
A wardrobe (mass , height , width , depth ), symmetric about the Y-Y axis, stands on a rough level floor as shown in the figure. A force is applied at mid-height on the wardrobe so as to tip it about point without slipping. What are the minimum values of the force (in newton) and the static coefficient of friction between the floor and the wardrobe, respectively?
- A
490.5 and 0.5
- B
981 and 0.5
- C
1000.5 and 0.15
- D
1000.5 and 0.25
GATE 2014 · Mechanical Engineering · Set 4 · IIT Kharagpur · printed as Q.37 in the ME section
Answer
From the official answer key published by IIT Kharagpur.
Worked solution
The wardrobe has mass , so its weight is:
The center of gravity is located on the axis of symmetry , which is at a distance of from the corner point . The height of the point of application of force is .
For impending tipping about point , the normal reaction acts entirely at . Taking moments about :
For tipping to occur without slipping, the friction force must not exceed the maximum static friction force:
Since vertical equilibrium requires :
Thus, the minimum values are and .
Answer: (A)
Practise Dry Friction, Wedges, Screws and Rolling Resistance
10 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Dry Friction, Wedges, Screws and Rolling Resistance
- GATE 2026 ME · Q48A block of 50 kg mass is on an inclined plane. The block is connected to another hanging mass M by an…
- GATE 2022 ME Set 1 · Q50Two rigid massless rods PR and RQ are joined at frictionless pin-joint R and are resting on ground at P and…
- GATE 2021 ME Set 2 · Q61A block of negligible mass rests on a surface that is inclined at 30° to the horizontal plane as shown in…
- GATE 2019 ME Set 1 · Q29A block of mass 10 kg rests on a horizontal floor. The acceleration due to gravity is 9.81 m/s2. The…
- GATE 2016 ME Set 1 · Q40A block of mass m rests on an inclined plane and is attached by a string to the wall as shown in the figure.…
- GATE 2014 ME Set 1 · Q41A block R of mass 100 kg is placed on a block S of mass 150 kg as shown in the figure. Block R is tied to…
Question from the official GATE 2014 ME paper (Set 4), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.