GATE 2015 ME Set 1 · Question 53
A machine element is subjected to the following bi-axial state of stress: ; ; . If the shear strength of the material is , the factor of safety as per Tresca's maximum shear stress theory is
- A
1.0
- B
2.0
- C
2.5
- D
3.3
GATE 2015 · Mechanical Engineering · Set 1 · IIT Kanpur
Answer
From the official answer key published by IIT Kanpur.
Worked solution
The in-plane principal stresses are determined from the given stress state (, , ):
Thus, and . Since it is a plane stress state, the third principal stress is .
The maximum shear stress is:
According to Tresca's maximum shear stress theory, the factor of safety (FOS) based on shear strength is:
Answer: (B) 2.0
Practise Energy Methods and Theories of Failure
21 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Energy Methods and Theories of Failure
- GATE 2015 ME Set 2 · Q21The uniaxial yield stress of a material is 300 MPa. According to von Mises criterion, the shear yield stress…
- GATE 2014 ME Set 2 · Q48Consider the two states of stress as shown in configurations I and II in the figure below. From the…
- GATE 2014 ME Set 3 · Q20Which one of following is NOT correct?
- GATE 2014 ME Set 4 · Q46A frame is subjected to a load P as shown in the figure. The frame has a constant flexural rigidity EI. The…
- GATE 2013 ME · Q5Two threaded bolts A and B of same material and length are subjected to identical tensile load. If the…
- GATE 2012 ME · Q26The homogeneous state of stress for a metal part undergoing plastic deformation is T = pmatrix 10 5 0 5 20 0…
Question from the official GATE 2015 ME paper (Set 1), IIT Kanpur. Solutions by PARIXO AI. All 65 questions of this paper.