GATE 2014 ME Set 3 · Question 20
Which one of following is NOT correct?
- A
Intermediate principal stress is ignored when applying the maximum principal stress theory
- B
The maximum shear stress theory gives the most accurate results amongst all the failure theories
- C
As per the maximum strain energy theory, failure occurs when the strain energy per unit volume exceeds a critical value
- D
As per the maximum distortion energy theory, failure occurs when the distortion energy per unit volume exceeds a critical value
GATE 2014 · Mechanical Engineering · Set 3 · IIT Kharagpur · printed as Q.10 in the ME section
Answer
From the official answer key published by IIT Kharagpur.
Worked solution
Let us evaluate the statements:
- (A) is correct: The Maximum Principal Stress Theory (Rankine's theory) assumes failure occurs when the absolute maximum principal stress reaches the yield strength, completely neglecting the intermediate and minimum principal stresses.
- (B) is NOT correct: The Maximum Shear Stress Theory (Tresca's theory) is conservative and safe for design, but the Maximum Distortion Energy Theory (von Mises theory) provides the most accurate and best agreement with experimental results for ductile materials.
- (C) is correct: Haigh's theory (Maximum Strain Energy Theory) posits that yielding begins when the total strain energy per unit volume reaches the strain energy per unit volume at the yield point in simple tension.
- (D) is correct: The Distortion Energy Theory (von Mises–Hencky theory) states that failure occurs when shear strain energy (distortion energy) per unit volume reaches that at yield in uniaxial tension.
Hence, statement (B) is the incorrect statement.
Answer: (B) The maximum shear stress theory gives the most accurate results amongst all the failure theories
Practise Energy Methods and Theories of Failure
21 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Energy Methods and Theories of Failure
- GATE 2014 ME Set 4 · Q46A frame is subjected to a load P as shown in the figure. The frame has a constant flexural rigidity EI. The…
- GATE 2013 ME · Q5Two threaded bolts A and B of same material and length are subjected to identical tensile load. If the…
- GATE 2012 ME · Q26The homogeneous state of stress for a metal part undergoing plastic deformation is T = pmatrix 10 5 0 5 20 0…
- GATE 2026 ME · Q34A steel plate having yield strength of 550 MPa, is subjected to biaxial state of stress as σx = σ and σy =…
- GATE 2025 ME · Q22The yield stress of a metal in uniaxial tension is 200 MPa. According to von Mises yield criterion, the…
- GATE 2025 ME · Q58An isotropic brittle material is tested in the universal testing machine. The stress-strain diagram for the…
Question from the official GATE 2014 ME paper (Set 3), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.