GATE 2015 ME Set 2 · Question 18
A gas is stored in a cylindrical tank of inner radius 7 m and wall thickness 50 mm. The gage pressure of the gas is 2 MPa. The maximum shear stress (in MPa) in the wall is
- A
35
- B
70
- C
140
- D
280
GATE 2015 · Mechanical Engineering · Set 2 · IIT Kanpur
Answer
From the official answer key published by IIT Kanpur.
Worked solution
Since the ratio of inner radius to wall thickness is , the tank can be analyzed as a thin-walled cylinder.
The principal stresses in the wall of the pressurized cylinder are:
1. Circumferential (hoop) stress:
2. Longitudinal stress:
3. Radial stress on the outer surface (where atmospheric pressure is taken as reference gauge pressure):
The absolute maximum shear stress in the wall is:
Option (B) corresponds only to the in-plane maximum shear stress , which is not the absolute maximum.
Answer: (C) 140
Practise Thin Pressure Vessels
11 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Thin Pressure Vessels
- GATE 2015 ME Set 3 · Q27A cylindrical tank with closed ends is filled with compressed air at a pressure of 500 kPa. The inner radius…
- GATE 2014 ME Set 4 · Q41A thin gas cylinder with an internal radius of 100 mm is subject to an internal pressure of 10 MPa. The…
- GATE 2013 ME · Q21A long thin walled cylindrical shell, closed at both the ends, is subjected to an internal pressure. The…
- GATE 2012 ME · Q10A thin walled spherical shell is subjected to an internal pressure. If the radius of the shell is increased…
- GATE 2026 ME · Q51A cylindrical pressure vessel made of steel has diameter of 3 m and wall thickness of 15 mm. For steel,…
- GATE 2024 ME · Q57The figure shows a thin cylindrical pressure vessel constructed by welding plates together along a line that…
Question from the official GATE 2015 ME paper (Set 2), IIT Kanpur. Solutions by PARIXO AI. All 65 questions of this paper.