PARIXO GATE · ME Open the app

GATE 2015 ME Set 2 · Question 19

1 markMultiple choiceTheory of MachinesPlanar Mechanisms, Mobility and Inversions

The number of degrees of freedom of the planetary gear train shown in the figure is

Figure 1 for GATE 2015 ME Set 2 question 19
  1. A

    0

  2. B

    1

  3. C

    2

  4. D

    3

GATE 2015 · Mechanical Engineering · Set 2 · IIT Kanpur

Answer
(C)

From the official answer key published by IIT Kanpur.

Worked solution

The degrees of freedom () of a planar mechanism can be determined using Kutzbach's criterion:

where:

  • is the number of links:

1. Fixed frame (ground)
2. Sun gear (50 teeth)
3. Arm
4. Planet gear (20 teeth)
Thus, .

  • is the number of lower pairs (revolute joints with 1 DOF):

1. Pin joint between ground and sun gear
2. Pin joint between ground and arm
3. Pin joint between arm and planet gear
Thus, .

  • is the number of higher pairs (gear mesh with 2 DOF before constraint / rolling with slip with 1 degree of constraint):

1. Meshing contact between sun gear and planet gear
Thus, .

Substituting these values into Kutzbach's equation:

Since neither the sun gear nor the arm is fixed, two independent inputs are required to specify the motion of all links.

Answer: (C) 2

Practise Planar Mechanisms, Mobility and Inversions

14 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.

More from Planar Mechanisms, Mobility and Inversions

Question from the official GATE 2015 ME paper (Set 2), IIT Kanpur. Solutions by PARIXO AI. All 65 questions of this paper.