GATE 2015 ME Set 2 · Question 45
In a certain slider-crank mechanism, lengths of crank and connecting rod are equal. If the crank rotates with a uniform angular speed of and the crank length is , the maximum acceleration of the slider (in ) is ________
GATE 2015 · Mechanical Engineering · Set 2 · IIT Kanpur
Answer
From the official answer key published by IIT Kanpur.
Worked solution
The acceleration of the slider in a slider-crank mechanism is given by:
where is the crank length, is the crank angular speed, and is the ratio of connecting rod length to crank radius.
Given:
- Crank radius,
- Crank angular speed,
- Connecting rod length equals crank length, so
The acceleration is maximum at the inner dead center (IDC), where :
Substitute the given values:
Answer: 117.6 (acceptable range: 115 to 120)
Practise Velocity and Acceleration Analysis
17 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Velocity and Acceleration Analysis
- GATE 2015 ME Set 3 · Q14In the figure, link 2 rotates with constant angular velocity ω2. A slider link 3 moves outwards with a…
- GATE 2014 ME Set 2 · Q49A rigid link PQ of length 2 m rotates about the pinned end Q with a constant angular acceleration of 12…
- GATE 2014 ME Set 3 · Q48A slider-crank mechanism with crank radius 60 mm and connecting rod length 240 mm is shown in figure. The…
- GATE 2013 ME · Q6A link OB is rotating with a constant angular velocity of 2 rad/s in counter clockwise direction and a block…
- GATE 2012 ME · Q20In the mechanism given below, if the angular velocity of the eccentric circular disc is 1 rad/s, the angular…
- GATE 2024 ME · Q54At the instant when OP is vertical and AP is horizontal, the link OD is rotating counter clockwise at a…
Question from the official GATE 2015 ME paper (Set 2), IIT Kanpur. Solutions by PARIXO AI. All 65 questions of this paper.