GATE 2015 ME Set 2 · Question 56
For the same values of peak pressure, peak temperature and heat rejection, the correct order of efficiencies for Otto, Dual and Diesel cycles is
- A
- B
- C
- D
GATE 2015 · Mechanical Engineering · Set 2 · IIT Kanpur
Answer
From the official answer key published by IIT Kanpur.
Worked solution
The thermal efficiency of an air-standard power cycle is given by:
where is the heat rejected and is the heat supplied.
For the condition where peak pressure, peak temperature, and heat rejection are the same:
1. On a diagram, the maximum temperature and pressure state point is identical for all three cycles.
2. Since the slope of a constant-volume line on a diagram is steeper than that of a constant-pressure line (), tracing backwards from the peak state reveals that the area under the heat addition curve is largest for the Diesel cycle (heat added at constant pressure), intermediate for the Dual cycle (part constant volume, part constant pressure), and smallest for the Otto cycle (heat added at constant volume).
Hence,
Since is constant, a higher heat input yields a higher efficiency:
Answer: (B)
Practise Air-Standard IC Engine Cycles (Otto, Diesel, Dual)
14 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Air-Standard IC Engine Cycles (Otto, Diesel, Dual)
- GATE 2015 ME Set 3 · Q35An air-standard Diesel cycle consists of the following processes: 1-2: Air is compressed isentropically.…
- GATE 2014 ME Set 1 · Q57In an air-standard Otto cycle, air is supplied at 0.1 MPa and 308 K. The ratio of the specific heats (γ) and…
- GATE 2014 ME Set 3 · Q59A diesel engine has a compression ratio of 17 and cut-off takes place at 10% of the stroke. Assuming ratio…
- GATE 2014 ME Set 4 · Q59In a compression ignition engine, the inlet air pressure is 1 bar and the pressure at the end of isentropic…
- GATE 2025 ME · Q32The thermal efficiency of an ideal air-standard Otto cycle is 0.5. The value of specific heat ratio of air…
- GATE 2022 ME Set 1 · Q62An engine running on an air standard Otto cycle has a displacement volume 250 cm3 and a clearance volume…
Question from the official GATE 2015 ME paper (Set 2), IIT Kanpur. Solutions by PARIXO AI. All 65 questions of this paper.